High Performance Water-based Wood Grain Filler
Email to friend
NEW High Performance Clear, water-based wood grain filler
Available in 1 US Quart (950ml) or US 1Pint (475ml)
GT water-based High Performance Clear Wood Grain Filler will perform 15-20% better than the original clear grain filler. It has higher solids, better fill, and will perform better in less coats. This clear gel grain filler helps achieve a clear, glass smooth finish on hard to fill woods such as oak, ash, walnut mahogany, cherry, birch and others. This grain filler penetrates and seals the pores minimizing the absorption of topcoats, achieving a glass smooth clear finish in less coats. It can be tinted with water soluble trans tints and dyes to accent the grains and pores to help attain your desired look.
Ideal Customers For Clear Wood Grain Filler
- Luthiers
- Cabinet refinishers
- Furniture makers
- Gunstock finishers
- Cabinet makers
- Piano restoration
- Antique restoration
- DIY woodworking hobbyists
Ideal for using as a wood grain filler on:
- Guitars and other wood instruments
- Tabletops
- Pianos
- Cabinets
Clear Wood Grain Filler Benefits
- Grain Filler dries in 30-45 minutes for a faster build
- Crystal clear when dry
- Easy sanding
- Nonflammable
- Low odor and low VOC
- Can be tinted with water-soluble colorants or dyes
- Can be thinned with water
- More OSHA-friendly than solvent-based
- Lower insurance premiums
- Minimal shrinkage
- Water clean-up
Clear Wood Grain Filler Directions For Use
Surface Preparation: The surface must be clean and dry (free from all dirt, oil, wax, and polish) before using the Clear Wood Grain Filler. Sand surface thoroughly. Remove all dust with a vacuum, forced air, or a damp cloth (water).
Directions For Use: Clear Wood Grain Filler should be applied after the piece is stained, and/or a seal coat has been applied.
- Stain and seal coat must be dry and lightly sanded with 220-grit or finer sandpaper.
- Grain Filler can be tinted with water-soluble colorants or dyes.
- If no stain or seal coat is used, you may apply Clear Grain Filler to the raw wood.
- Grain Filler may be applied with a soft cloth, using a circular motion, much like applying paste wax. Or work Grain Filler generously into open wood grain pores with a small squeegee or flexible putty knife.
- Inspect to see if the grain is completely filled, then scrape or squeegee to remove excess.
- Let dry 30-45 minutes, then lightly sand with 320 grit paper.
- If the grain is not completely filled, repeat the application process.
- 2-3 coats of Grain Filler are recommended.
- Allow over_night dry time and lightly sand before applying topcoats.
| SKU | M-AC1 |
| Brand | Guitar Templates |
Be The First To Review This Product!
Help other Guitar Templates users shop smarter by writing reviews for products you have purchased.
Sale Price:
Others Also Bought
Others Also Bought
Some Team Favourites
Look What's New
More From This Category
